Realflight 7 activation key. IMPORTANT SAFETY RECALL NOTICE
February 20, 2009
Smith And Wesson Shield Recall Serial Numbers
PRODUCT: Walther PPK and PPK/S pistols
I have a 10-7 and a model 64-3. Both have a pinned barrel which was deleted some time in 1981. Both also were shipped in 1981 based on the serial numbers. The m64 has a 7D56xxx, and the m10 is 8D97xxx. If I recall correctly, they ran up into the 9D xxxxx range before switching to the 3 alpha prefix. This recall applies to all Walther PPK and PPK/S pistols manufactured by Smith & Wesson from March 21, 2002, until February 3, 2009. The Serial Numbers of the pistols subject to this recall are as follows: STOP USING YOUR PISTOL AND RETURN IT TO SMITH & WESSON AT ONCE. Any unintended discharge of a firearm has the potential for causing injury.
DESCRIPTION OF THE HAZARD: Smith & Wesson has identified a condition that may exist in certain PPK and PPK/S pistols which may permit a round to be discharged without the trigger being pulled. When the manual safety is disengaged, Smith & Wesson’s Product Engineering Group has determined that the possibility exists in certain firearms that lowering the hammer may cause a chambered round to fire.
This recall applies to all Walther PPK and PPK/S pistols manufactured by Smith & Wesson from March 21, 2002, until February 3, 2009. The Serial Numbers of the pistols subject to this recall are as follows:
DESCRIPTION OF THE PRODUCT INVOLVED:
0010BAB - 9999BAB
0000BAC - 9999BAC
0000BAD - 9999BAD
0000BAE - 9999BAE
0000BAF - 9999BAF
0000BAH - 9999BAH
0000BAJ - 9999BAJ
0000BAK - 9999BAK
0000BAL - 5313BAL
0000BAM - 1320BAM
0000LTD - 0499LTD
0001PPK - 1500PPK
0026REP - 0219REP
0001WLE - 0459WLE
REMEDY/ACTION TO BE TAKEN:
STOP USING YOUR PISTOL AND RETURN IT TO SMITH & WESSON AT ONCE.
Any unintended discharge of a firearm has the potential for causing injury, and we ask that you stop using your pistol immediately.
To facilitate the repair of your pistol, please complete the Safety Recall Form or contact Smith & Wesson's customer service department at 855-774-8527 to receive instructions for the return of your pistol to Smith & Wesson.
When you return your pistol to Smith & Wesson, we will replace the existing hammer block feature with a new part at no cost to you. Your firearm will be returned as quickly and efficiently as possible.
VERIFICATION OF CORRECTIVE ACTION:
When your pistol is returned, you should note a punch dot which appears at the back of the frame. See the photograph below.
Smith And Wesson Shield Wiki
This marking is verification that the new hammer block has been installed and that your pistol is safe to handle.
CONSUMER CONTACT: To receive a FedEx pre-paid label and shipping instructions please call 855-774-8527.
IF YOU HAVE ANY QUESTIONS ABOUT THIS RECALL, PLEASE CONTACT SMITH & WESSON AT 855-774-8527